AVCO-BIOLIT NFB is a surfactant, which possesses very good wetting and cleaning properties, and can therefore be used in a wide- range of textile preparation and bleaching processes, such as de-sizing, kier boiling, alkali treatment, bleaching, wetting and washing treatments.AVCO-BIOLIT NFB is composed of biodegradable ingredients with no potential for bio-accumulation, and with no evolution of toxic compounds during biodegradation.AVCO-BIOLIT NFB is environmentally acceptable, and can be regarded as a “GREEN” product.
SPECIFICATION:
Appearance |
Colourless,slightly viscous, haze liquid. |
Chemical nature |
Blend of nonionic (APEO free) and anionic surfactants |
Compatibility |
Is not compatible with cationic products. |
Foaming tendency |
Low foaming |
pH (10% sol.) |
7.5 ± 0.5 |
Resistance to: mild acids, mild alkalis, electrolytes, hard water |
} Good |
Solubility |
Miscible with water at any ratio. |
Storage |
Solidifies below O°C. Fully usable after thawing and agitating. Shelf life is at least 12 months. |
PROPERTIES & USES:
- Rapid wetting agent, applied in neutral, alkaline and mild acid range, for both
cold
and hot liquors, on all types of textiles.
- Very efficient detergent and wetting agent for high-speed machines or those with
tendency to foam, e.g. jet machines, overflow machines, high speed continuous
bleaching, scouring and washing ranges.
- Stable to chemicals normally used in textile preparation and bleaching processes,
such
as alkalis, mild acids, electrolytes, hypochlorite, sodium-chlorite, persulphates
and
hydrogen-peroxide.
- Good wetting agent for de-sizing bleaching and scouring operations.
- Good kier-boiling agent.
- Can be used in dye-bath, to ensure level pick up of dyestuffs.
- Good soaping agent for reactive dyestuffs.
APPLICATION:
AVCO-BIOLIT NFB can be applied as is, or pre diluted with cold water.
Amounts of application are the following:
a. Padding methods:
-
On raw material use 2 – 4 g/l
-
On prepared material use1 – 2 g/l
b. Exhaustion methods:
-
On raw material use 1 – 2 g/l
-
On prepared material use 0.5 – 2 g/l
|